For us to proceed with any work, we require all clients to sign, date and print their name on the quotation sent to you and return to our address.
If you have chosen a resin bound finish, please confirm below your resin choice using the code on the rear of the sample.
Our prices are guaranteed for 3 months from the date of the quote, subject to 3rd party price freezes/increases/decreases.
On receipt of the signed quotation we will contact you to confirm a start date.
A deposit must be received no later than 7 days prior to start date. If your work is for a residential crossover approved by Surrey County Council, then no deposit is required.
A contract will exist once the deposit is received.
Balance payment terms are strictly 30 days from date of invoice. The invoice will be issued on completion of these works. If the Customer fails to make any payment due to the Supplier under the Contract by the due date for payment, then the Customer shall pay interest on the overdue amount at the rate of 8% per cent per annum above Barclays Bank Plc’s base rate from time to time. Such interest shall accrue on a daily basis from the due date until actual payment of the overdue amount, whether before or after judgment. The Customer shall pay the interest together with the overdue amount.
Due to the nature of our business, confirmed dates for work may change. In the unlikely event of this happening, we will give you as much notice as possible.
All work is not guaranteed for oil and chemical spillage or inappropriate use. Due to the nature of patch works, this is also not guaranteed.
Kane Construction Services Ltd will not be held responsible for weed growth from underlying surfaces unless we have undertaken full construction. Weed control on existing surface is down to the client to have suitably treated the surface prior to our commencement of works.
Please note work will not be guaranteed by Kane Construction Services Ltd for any cracking or subsidence in the underlying surfaces if it has not been prepared by us. If we do not carry out the groundwork, we will not be held responsible for standing water issues.
If our quotation is priced of a plan, information supplied or the site is prepared by others, then it will be subject to a measurement either prior to commencement of works or after works are completed. Our quotation will then be subject to price change according to correct measurements.
Although every care is taken in our initial surveys there is always the possibility of unforeseen circumstances, usually below ground and although rare, Kane Construction Services Ltd reserves the right to review the contract and associated costs.
Kane Construction Services Ltd reserve the right to revise our quotations at any point during the course of works if specifications change from our original quotations.
Please be aware all aggregates are natural products and can vary throughout batches. The nature of the materials and processes used, make it unavoidable that apparent variation in texture and colour of the surface material may occur. Whilst every possible care will be taken, the company cannot guarantee colour and texture matching closer than those inherent to the materials and processes used. Once the surface is laid over a period of time it will lose its shine and give a natural, matt stone finish. The texture of finish may vary and working marks may also be visible under light at obscure angles. We endeavour to provide a seamless finish to the surface, however this is not always possible. In such circumstances a joining or expansion strip may be used.
Resin Bound Surfaces
We will endeavour to provide a seamless finish to the surface; however this is not always possible. In such circumstances a joining or expansion strip may be required.
Without prejudice to any remedies that the company might have in the cancellation of an order by the purchaser, Kane Construction Services Ltd reserves the right to recover such costs that have occurred, however incurred.
Kane Construction Services Ltd shall not be held responsible for the minor departures from the contract specifications or drawings made necessary by site conditions or unforeseen circumstances.
Kane Construction Services Ltd will endeavour to make the new surface as level as practically possible. A tolerance of 20mm per m² is allowed.
In addition to its statutory obligations, Kane Construction Services Ltd, warrants a 10 year period on completion of the contract and will make good, free of charge, any defects which are due to faulty workmanship or materials, provided the facility is treated with reasonable care and any maintenance instructions have been adhered to. Written notice of any claim against this warranty must be received within 14 days of the warranty period.
Kane Construction Services Ltd cannot be held responsible for the on-going structural or matrix condition of existing surfaces, or new surfaces laid by others, onto which its resin bound coating is applied.
It is the responsibility of the buyer to inform Kane Construction Services Ltd of any existing and unwanted pooling prior to the application of the specialist resin coating. Whilst every effort will be taken to remove any reported pooling, Kane Construction Services Ltd can accept no responsibility for standing water or other drainage issues on existing surfaces or new surfaces laid by others.
The above guarantee does not cover sub-surface issues unless the underlying substrate was constructed and installed by Kane Construction Services Ltd.
It is important to note that the resin bound system is only suitable for use where the maximum weight of a vehicle using the surface does not exceed 2.5 tonnes and as such, the warranty will not extend to such circumstances.
The guarantee does not cover the following:-
Damage caused by forceful impact, point loading (inc. high heels), other mechanical damage and excessive usage.
Damage caused by reflective cracking or subsequent damage caused by reflective damage from the underlying base.
Damage caused by stones in tyres or dry steering.
Damage or staining caused by chemicals, solvents (general external agents).
Damage caused by repairs made to, or adjacent to, the surface or underlying structural layers.
A decrease in permeability caused by ingress of dirt, fine materials or other causes.
Mineralogical variations (this includes rust spotting) in the aggregate, which have an effect on its aesthetical or, physical or mechanical properties.
Damage as tree roots and deformation of any under laying structural layers or sink-age. Whilst resin bound surfacing is porous, it is only as porous as the natural soils will allow and in some circumstances will puddle for a short until it is allowed to disburse.
Hairline fractures may occur in very infrequent cases. This does not affect the overall performance of the surface and cannot be regarded as a defect. Any severe cracking forming within the surface will be mass filled by the company.
The nature of the materials and processes used make it unavoidable that apparent variation in texture and colour of the surface material may occur. Whilst every possible care will be exercised, the company cannot guarantee colour and texture matching closer to tolerances than those inherent in the materials and processes used. Once the surface is laid over a period of time it will lose its shine and give you a natural, matte stone finish.
Working in Partnership with
Recommended installers for material and products supplied by
Click on the different category headings to find out more. You can also change some of your preferences. Note that blocking some types of cookies may impact your experience on our websites and the services we are able to offer.
Essential Website Cookies
These cookies are strictly necessary to provide you with services available through our website and to use some of its features.
We provide you with a list of stored cookies on your computer in our domain so you can check what we stored. Due to security reasons we are not able to show or modify cookies from other domains. You can check these in your browser security settings.
Google Analytics Cookies
These cookies collect information that is used either in aggregate form to help us understand how our website is being used or how effective our marketing campaigns are, or to help us customize our website and application for you in order to enhance your experience.
If you do not want that we track your visist to our site you can disable tracking in your browser here:
Other external services
We also use different external services like Google Webfonts, Google Maps, and external Video providers. Since these providers may collect personal data like your IP address we allow you to block them here. Please be aware that this might heavily reduce the functionality and appearance of our site. Changes will take effect once you reload the page.
Google Webfont Settings:
Google Map Settings:
Google reCaptcha Settings:
Vimeo and Youtube video embeds: